Main Office
Dubai — Showroom
The Pinnacle Building, Sheikh Zayed Road, Office 607
Mon–Fri: 9:00 – 18:00
Apartment doors
An apartment door faces a cooled corridor rather than the weather, so the argument is rarely about heat. It is about what the building permits: a developer specification the new door has to answer to, a compartmented lobby, a card reader, and a service lift booked for every panel that goes up. We carry that paperwork alongside the making, and we work to whatever hours the management office sets.
- inward swing leaf action
- reader ready access
- developer spec finish match
Advantages of working with us
-
In-house production
Windows, doors and glazed structures are made at our own factory in the UAE. Manufacturing takes 3–5 weeks from the survey, and the dates are written into the contract.
-
Room measurement
After a free consultation, an engineer comes to measure within 48 hours and answers the technical questions on site — openings, profile, glass and hardware.
-
Delivery of products
We deliver with our own transport across Dubai and all Emirates, and the installation date is agreed in advance so the crew arrives with the finished units.
-
Installation on site
A "clean" installation is carried out – all construction debris is removed, and dust and dirt are cleaned. Work can be conducted with or without your presence. The date and time are discussed individually.
-
Guarantee
The structures we make and the installation our crews carry out are covered by one warranty under one contract. The profile system also carries the manufacturer's warranty — up to 20 years, depending on the system.
-
Service
Warranty cases are handled by the same crews that did the installation: send the address and photos, and in most cases we can say before the visit whether it is an adjustment, a gasket or a glass unit.
Replacing a door in an occupied tower
- Survey taken with the house rules read first Engineer on site within 48 hours
- Approval pack sent to the management office Drawings, finish and method statement
- Existing frame checked for how it is fixed Some are cast into the slab
- Fabrication, then delivery to the service lift Three to five weeks from approval
- Fitting inside the agreed working hours Protection laid from lift to doorway
- Removal of the old leaf planned with the building Route and timing agreed with management
What the building decides for you
-
Approved
Specification
Finish and profile follow house rules
-
Compartment line
Lobby
Some flats sit on a protected corridor
-
Cable route
Access
Loop left inside the frame for a reader
-
Quiet close
Hardware
Closer speed tuned for a shared hallway
-
Lift booked
Delivery
Panels sized to the service lift car
Let's calculate
the cost of glazing
Get a free calculation for your windows — just leave your number, we'll reply on WhatsApp within 15 minutes.
Pricing
Aluminium Windows and Doors Calculator
Choose the options — we’ll send the price on WhatsApp
What are we making
Shape and opening
Size
Width and height: 300–6000 mm. Not sure? Clear the fields — we’ll measure at the free survey.
Width under 300 mm — check that it is in millimetres.
Width over 6000 mm — we’ll confirm it at the survey.
Height under 300 mm — check that it is in millimetres.
Height over 6000 mm — we’ll confirm it at the survey.
Enter a whole number of units, 1 or more.
Glazing unit
Extras
Do you need a windowsill?
Do you need a coloured profile?
Do you need installation?
The honest downside
Before you replace an apartment door
An apartment door is the one part of the flat the building still has a say in. The corridor face, the profile and often the colour are set by the management office, so a new door changes a lot on the hallway side and little on the corridor side. A managed tower is the wrong place to expect a statement front door.
Nor will a new leaf cure every complaint. Corridor noise and cooking smells mostly come through the gap under the door and a gasket gone hard, and fresh seals on the existing leaf can do much of that work.
Where the flat opens onto a protected corridor, the door stops being a matter of taste: it has to be a certified fire-rated set, specified as one assembly. On an ordinary corridor, a new apartment door is still the right answer when the leaf is damaged, the frame has moved or the lock no longer meets its keep.
Consider instead
Fire-rated doors
Frequently asked questions
In almost every managed tower, yes. The management office holds a specification for what an apartment door may look like from the corridor and how it must behave in a fire, and they sign drawings before work starts. We prepare that submission as part of the order instead of leaving it with the owner.
Yes. A leaf can be finished differently on each face, so the corridor keeps the shade the building insists on while the hallway inside gets the colour you want. Both faces are coated at the factory, never painted in place.
Most of what people hear arrives past the door rather than through it — the gap under the leaf and a gasket that has gone hard. A continuous perimeter seal plus a drop seal at the bottom changes the experience far more than a heavier leaf.
For a short time, if it is planned well. Panels come up on a booked service-lift run, the old leaf goes back down the same way, and the corridor is kept protected while the frame is out. The hours are set by the management office, and the sequence is planned around them.
Brands we work with
Related pages
Nearby pages and the rest of the catalogue.
- Automatic doors
- Balcony doors
- Bi-fold doors
- Black doors
- Bronze doors
- Brown doors
- Corner sliding doors
- Double-leaf doors
- Entrance doors
- Fire-rated doors
- French doors
- Glass doors
Sections
Company
We are always happy to welcome you at our showroom
Showroom
Samples to see in person
Profiles, glass units and hardware to see and touch before you choose.
Dubai — Showroom
The Pinnacle Building, Sheikh Zayed Road, Office 607
Get directions 