Emirates Hills
Plots here were built one at a time to their owners' own architects, so almost nothing repeats: the arch over a stair landing, the double-height majlis window and the lift-and-slide door onto the lawn can all exist in a single house and nowhere else. That rules out catalogue sizes — every opening is measured on its own and drawn from scratch, and a replacement has to match a frame nobody else was given. The plots are wide, but the route from the gate to a facade runs past mature planting and decorative paving that has to survive the delivery. Houses of this size stay in use throughout, so the programme moves elevation by elevation rather than opening the whole envelope at once.
- drawn from scratch every opening
- one at a time how elevations run
- past mature planting route to the facade
What a house here demands
-
One-off
Openings
No two alike in the same villa
-
Double height
Majlis and stair
Divided into structural bays
-
Mechanically lifted
Large panes
Beyond what hands can carry
-
Sampled from the house
Finish
New work sits beside untouched bays
-
Elevation by elevation
Programme
The household stays in residence
Let's calculate
the cost of glazing
Get a free calculation for your windows — just leave your number, we'll reply on WhatsApp within 15 minutes.
Advantages of working with us
-
In-house production
Windows, doors and glazed structures are made at our own factory in the UAE. Manufacturing takes 3–5 weeks from the survey, and the dates are written into the contract.
-
Room measurement
After a free consultation, an engineer comes to measure within 48 hours and answers the technical questions on site — openings, profile, glass and hardware.
-
Delivery of products
We deliver with our own transport across Dubai and all Emirates, and the installation date is agreed in advance so the crew arrives with the finished units.
-
Installation on site
A "clean" installation is carried out – all construction debris is removed, and dust and dirt are cleaned. Work can be conducted with or without your presence. The date and time are discussed individually.
-
Guarantee
The structures we make and the installation our crews carry out are covered by one warranty under one contract. The profile system also carries the manufacturer's warranty — up to 20 years, depending on the system.
-
Service
Warranty cases are handled by the same crews that did the installation: send the address and photos, and in most cases we can say before the visit whether it is an adjustment, a gasket or a glass unit.
How a bespoke villa job runs
- Every opening measured on its own Engineer on site within 48 hours
- A drawing set produced for this house Not adapted from a standard type
- Existing profile, colour and sheen recorded So a single replaced bay does not stand out
- Lifting and delivery route agreed Driveway, paving and planting boarded over
- Manufacturing in our Dubai factory Three to five weeks from the signed drawing
- Elevations handed back one by one Rooms returned to use as each is finished
Brands we work with
Articles
Frequently asked questions
That is usually where the job starts. The original frames were drawn for the plot rather than chosen from a list, so we begin by recording what is actually there — the depth of the profile, the width of the sightline, how the bead and the seal sit, the colour and the sheen of the coating. From that we draw a frame that reads the same from the garden while the section behind it is a current thermally broken one. Where a whole elevation is being renewed the match matters less; where one bay is replaced beside untouched neighbours it decides whether the change is visible at all.
It is designed as a structure before it is designed as a window. A tall opening is divided into bays with a reinforced transom or a supported mullion carrying the load, so no single sash is asked to hold a pane it cannot. Each pane is then sized to what can be lifted and turned inside the room rather than to what looks best on paper. The division lines are drawn where the architecture already has them — a floor level, a stair landing — so the added structure reads as part of the elevation instead of an apology for it.
That is planned at the survey, not on the delivery day. We walk the route from the gate to each elevation and record what is under it — decorative paving, irrigation lines, lawn edging, a pool surround — then decide where the lorry stops and where material transfers to a trolley or lifting frame. Boards go down over anything asked to take weight. If a route genuinely will not carry the load, the glass goes in through a different elevation instead of being forced along that one.
Yes, and on a house this size it normally has to. Work runs elevation by elevation: one facade is opened, glazed, sealed and cleaned before the next is touched, so the rest of the house keeps its cooling and its privacy. The crew works to hours agreed with the household, uses one entrance and one internal route, and the site is closed each evening rather than left sheeted over for weeks. On a long programme that also means the first rooms are back in use while the last are still being drawn.
Related pages
Nearby pages and the rest of the catalogue.
- Al Furjan
- Al Quoz
- Al Raha Beach
- Al Reem Island
- Arabian Ranches
- Bur Dubai
- City Walk
- Discovery Gardens
- Dubai Hills Estate
- Jumeirah Islands
- Jumeirah Village Triangle
- MBR City
Sections
Company
We are always happy to welcome you at our showroom
Main Office
Dubai — Showroom
The Pinnacle Building, Sheikh Zayed Road, Office 607
Mon–Fri: 9:00 – 18:00
Showroom
Samples to see in person
Profiles, glass units and hardware to see and touch before you choose.
Dubai — Showroom
The Pinnacle Building, Sheikh Zayed Road, Office 607
Get directions 